How to use Autel MK808 Erase BMW ABS/DSC Warning Light Error codes

 Car model and year: BMW 3 Series F31 2016 .
Purpose: Turn off the ABS/DSC Warning Light
Tool used: Autel MaxiCOM MK808

Procedure

Plug the connector into the OBD2 port, let’s go to Autel MK808,

 

Diagnostics >> BMW >> Manual selection >> 3 Series >> F30/F31/F35 >> Yes

 

Turn the ignition off, please wait...

 

Turn the ignition on, please wait...

 

It is communicating with the ECU, and it’ll give us a big list of a system that will allow us to diagnose. I need to find the ABS/DSC system.

 

Diagnosis >> Control unit >> Chassis

  

 

ABS - DSC(ABS-Dynamic stability control) >> Read codes

 

It’s telling one fault code here: 48082A - wheel speed sensor(WSS): right rear voltage supply circuit short to battery(+)

 

It means that there is a fault with the rear right ABS sensor. It is a very common failure on BMW’s actually, what I had done was to change the ABS sensor over, and put a new one in.

 

So go back to clear codes,

ESC >> Erase codes

 

DTCs and freeze data will be deleted, press “Yes” to continue.

 

Codes have been successfully erased. Press “OK” to finish.

 

The ABS warning light has gone!

We can return to “Read codes” again to verify as well.

 

This is using Autel MK808 Diagnostic Tool to reset ABS for a BMW 3 series F31, it can also works on BMW 3 Series E36, E46, E90, E91, E92, E93, F30, F35, BMW 4 Series F32, F33, F36, BMW 5 Series E39, E60, F07, F10, F11...etc.

http://blog.auteldiag.com/bmw-3-series-f31-2016-abs-dsc-warning-light-reset-via-autel-mk808/